1
3D Printers / Questions for Lasershark wiring
« on: November 08, 2014, 12:34:01 PM »
Hi Jeff,
I have questions about Lasershark board. I am wiring Galvo Set (Power Supply, Mirrors, Steppers) and 150mW 405nm Laser. I use my part from prytech printer.
I can connect Channel X Gnd and Channel Y Gnd and ttl to usb to ramps board.
but i am not sure How to wiring Laser to Lasershark board. That you show from
http://macpod.net/electronics/lasershark/lasershark_usage.php
1. Lasershark have Channel A,B.C and Interlock. with port that i should connect with?
2. in pryntech board used power 12v dc 2A. I am not sure Lasershark should have power to run Laser or not? or Just power from ttl to usb from ramps board.
regards
sontaya
I have questions about Lasershark board. I am wiring Galvo Set (Power Supply, Mirrors, Steppers) and 150mW 405nm Laser. I use my part from prytech printer.
I can connect Channel X Gnd and Channel Y Gnd and ttl to usb to ramps board.
but i am not sure How to wiring Laser to Lasershark board. That you show from
http://macpod.net/electronics/lasershark/lasershark_usage.php
1. Lasershark have Channel A,B.C and Interlock. with port that i should connect with?
2. in pryntech board used power 12v dc 2A. I am not sure Lasershark should have power to run Laser or not? or Just power from ttl to usb from ramps board.
regards
sontaya