Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - sontaya

Pages: [1]
1
3D Printers / Questions for Lasershark wiring
« on: November 08, 2014, 12:34:01 PM »
Hi Jeff,

I have questions about Lasershark board. I am wiring Galvo Set (Power Supply, Mirrors, Steppers) and  150mW 405nm Laser. I use my part from prytech printer.

I can connect Channel X Gnd and Channel Y Gnd and ttl to usb to ramps board.

but i am not sure How to wiring Laser to Lasershark board. That you show from
http://macpod.net/electronics/lasershark/lasershark_usage.php

1. Lasershark have Channel A,B.C and  Interlock. with port that i should connect with?

2. in pryntech board used power 12v dc 2A. I am not sure Lasershark should have power to run Laser or not? or Just power from ttl to usb from ramps board.

regards
sontaya

2
3D Printers / Laser shark for SLA printers
« on: June 28, 2014, 01:32:35 PM »
Hi macpod

I am sontaya. I have to buy Pryntech printer. with marlin firmware. but firmware and host software a bit difficult to use. also just one step .it's not enough.

I want to change to Laser shark with two step. what your firmware and host controller. can you show me screen of your host control.

I want to know Laser shark. can use firmware like sprinter or Marlin firmware on arduino. My favorite controller software is creative workshop (envisionlabs.net)

My DLP printer use Ramps1.4 ,sprinter firmware ,creative workshop for controller. it's easy to working with.

if I can control laser on Laser shark with creative workshop ,it's will be great.

please advice me how to use laser shark with SLA printer

Thank you

Pages: [1]