Messages

1

3D Printers / power of laser

« on: May 05, 2014, 09:23:00 AM »

Hello Jeff, I am ready to make the first test of 3d printing with your lasershark, I had already ordered a few months ago, a 100mW laser from 405-410 nm 3.0-5.0V www.odicforce.com, unfortunately project  a line instead of a point, my fault, I had not read well. I would ask that the power of laser advise me to buy and where to buy, I would also like to explain to me where to connect the laser to the lasershark and where to connect the external 5 volt power supply.
I thank you in advance for your answer, and I'll keep you updated on the first test, maybe do a movie and place it in your forum
sorry for the translation