Macpod LLC is a small company that specializes in software, embedded software, electronics design, and small hardware prototyping.
Mar 20, 2014 - A new version of the LaserShark firmware is out (V2.2 aka V3). This version improves support for bulk (vs iso transfers) and adds a new command to clear the ringbuffer internal to the LaserShark... This should be very helpful for 3D Printer folks.
Jan 8, 2014 - I built a completely open source dual stepper motor driver that I call the TwoStep. This board is intended to be paired with a LaserShark for 3d printer, and other applications. Check it out in the Electronics section!
Jan 1, 2014 - A new version of the LaserShark firmware is out (V2.1 aka V3). This version allows the Lasershark units to act as a UART bridge for other peripherals.