« previous next »
Pages: [1]

Author Topic: Re: Laser shark for SLA printers  (Read 16787 times)

giorgino3d

  • Newbie
  • *
  • Posts: 2
  • Karma: +0/-0
    • View Profile
Re: Laser shark for SLA printers
« on: November 06, 2014, 10:26:33 AM »
Hi,
I have all material

-laser 470nm 300mw
-lasershark
-twostep
-galvo

but I don't understand how to connect them.

Kind Regards
Logged

Macpod

  • Administrator
  • Full Member
  • *****
  • Posts: 179
  • Karma: +3/-0
    • View Profile
Re: Re: Laser shark for SLA printers
« Reply #1 on: November 06, 2014, 08:31:57 PM »
So that I may assist you can you please post:
1. Links to where you purchased these items
2. Pictures of the galvos and lasers.
  • -Taking a picture of the back of the black plastic laser driver would be good (this has markings that indicate what connects where
  • Closeups of the connectors will also help
Logged

giorgino3d

  • Newbie
  • *
  • Posts: 2
  • Karma: +0/-0
    • View Profile
Re: Re: Laser shark for SLA printers
« Reply #2 on: November 07, 2014, 05:39:43 AM »
Logged

Macpod

  • Administrator
  • Full Member
  • *****
  • Posts: 179
  • Karma: +3/-0
    • View Profile
Re: Laser shark for SLA printers
« Reply #3 on: November 09, 2014, 12:44:32 AM »
giorgino3d, I have split this topic since this relates to your own builds vs sontayas.

Thank you for your links. Your galvos do not have normal connections so you will need to manually wire them to the board. The following picture will show you:


I do not have enough information to help you with connecting your laser. Where did you buy this from? Is there a datasheet? Can you please take a picture of the bottom of plastic driver board?
Logged
Pages: [1]
« previous next »