Hello,
I wasn't too sure that this topic was still achieve, but it seemed most relevant since it is about 3d printing that I have my query. I am just at the beginnings of understanding SLA as a 3d printing option, and the thought of using your board to achieve this is exciting. However, a lot of the build areas that are possible across all SLA technologies, seems to be a little small, for what I am after, and I wanted to know whether it was possible to increase this using the configuration in the attached picture. Or am I just asking for a whole lot of pain? Any direction on this would be greatly appreciated.
Regards,
P.S On the drawing I now realise I spelt Galvos wrong, apologies
I wasn't too sure that this topic was still achieve, but it seemed most relevant since it is about 3d printing that I have my query. I am just at the beginnings of understanding SLA as a 3d printing option, and the thought of using your board to achieve this is exciting. However, a lot of the build areas that are possible across all SLA technologies, seems to be a little small, for what I am after, and I wanted to know whether it was possible to increase this using the configuration in the attached picture. Or am I just asking for a whole lot of pain? Any direction on this would be greatly appreciated.
Regards,
P.S On the drawing I now realise I spelt Galvos wrong, apologies