Author Topic: power of laser  (Read 11040 times)

cosimocnc

  • Newbie
  • *
  • Posts: 1
  • Karma: +0/-0
    • View Profile
power of laser
« on: May 05, 2014, 09:23:00 AM »
Hello Jeff, I am ready to make the first test of 3d printing with your lasershark, I had already ordered a few months ago, a 100mW laser from 405-410 nm 3.0-5.0V www.odicforce.com, unfortunately project  a line instead of a point, my fault, I had not read well. I would ask that the power of laser advise me to buy and where to buy, I would also like to explain to me where to connect the laser to the lasershark and where to connect the external 5 volt power supply.
I thank you in advance for your answer, and I'll keep you updated on the first test, maybe do a movie and place it in your forum
sorry for the translation

Macpod

  • Administrator
  • Full Member
  • *****
  • Posts: 179
  • Karma: +3/-0
    • View Profile
Re: power of laser
« Reply #1 on: May 05, 2014, 06:28:22 PM »
Hi Cosimo,

I've been busy with software so I haven't had time to make my 3d printer hardware such. Because of this I cannot say with certainty what laser you should get. My suggestion would be to follow what the opensl folks are using:

http://pryntech.com/forum/viewtopic.php?id=142

http://pryntech.com/forum/viewtopic.php?id=126

Here is a link to the ebay auction:
http://www.ebay.com/itm/130955440710



The lasershark does not power lasers, it only controls their modulation.

You will need a 12v DC power supply for this laser from ebay. A switching power supply should be fine.



Hope that helps
« Last Edit: May 05, 2014, 06:30:46 PM by Macpod »