Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Necdet

Pages: [1]
1
LaserShark Support / Re: Lasershark help
« on: July 29, 2015, 09:53:49 AM »
I would like to use those device for my first SLA 3D printer.
Thanks for warning me about devices.

I hope that Lasershark will work well in 3d printer.
I am looking for some new friends who can help me about that.

Thank you for help

2
LaserShark Support / Re: Lasershark help
« on: July 28, 2015, 05:00:32 PM »
Hi Macpod,

Thanks for information,

Please see attached picture for what I have in my laser system:


-Lasershark
-30K scanning system
-405nm 150mV laser module


May I ask you that how can we use OpenLase in windows 8 ?

How can we add a new lasershow or any other file  to OpenLase ?

thanks for help


3
LaserShark Support / Lasershark help
« on: July 27, 2015, 04:45:34 AM »
Hello Macpod,

May I ask you same help about Lasershark ?

1-
I tryed to run my lasershark but I get some error, here below:
(I have lasershark 2.1) (windows 8.1)

iSerialNumber:B25E909094919535
Getting FW Major version: 2
Geting FW Minor vrsion: 2
Your FW is not capable of proper bulk transfer or clear commands.Please upgrade your firmware.
libusb:warning lisusb_exit some lisusb_devices were leaked.

2-
How can I connect laser module to lasershark ?
I have laser control module. Please, see attached pictures what I have 



3-
Which software do you recommed to use for laser show ?
Which software is better for Lasershark ?


Thanks advance for your help

Necdet

Pages: [1]